How to Install Your Verequa Showerhead

Turn Off the Water

Make sure your shower is completely turned off before beginning the installation.

Remove Your Existing Showerhead

Unscrew your existing showerhead from the shower arm.

• Try removing it by hand first.
• If necessary, use an adjustable spanner carefully.
• Keep a towel nearby for any remaining water.

Clean the Shower Arm

Remove any old plumber’s tape, dirt or residue from the threaded end of the shower arm. A clean thread helps create a more secure, leak-resistant connection.

Apply the Plumber’s Tape

Wrap the supplied plumber’s tape firmly around the threaded end of the shower arm. Apply it evenly so the threads are properly covered.

Attach the Connector

Screw the Verequa connector onto the threaded shower arm. Tighten it securely by hand without over-tightening.

Connect the Hose

Attach one end of the stainless steel hose to the connector. Hand-tighten until the connection feels secure.

Attach the Verequa Showerhead

Connect the other end of the hose to your Verequa showerhead and tighten the connection securely by hand.

Turn the Water Back On

Slowly turn the shower on and allow the water pressure to build. Check the connector, hose and showerhead connections for any leaks.

Adjust the Showerhead

Position the showerhead at your preferred height and angle for a comfortable shower experience.

Test Your Verequa Showerhead

Turn the shower on fully and test the different spray settings. Check all connections once more to make sure everything is secure and working correctly.